Decal Installation
Home Christian Animals Flowers Vehicles Aircraft Hunting & Fishing Sports Military Music Fireman Medic Police Native American Ribbons Rodeo Racing Misc. Decal with Photo Decal Installation Vinyl Color Chart F.A.Q. Contact Sizes

Vinyl decals will stick to about any clean smooth surface. Make sure it is free of dirt, wax and grease. We recommend installation temp. of surface between 60 - 90 degrees. Tools to have on hand for install - tape measure, masking tape, glass cleaner, squeegee or credit card.

Note: Our decals are 100% guaranteed against manufacturing defects.  We guarantee our decals when we install them but we can not guarantee them, if they are not installed properly or you destroy it during installation.

Do Not wash vehicle for at least a week after decal installation to insure that decal adhesives securely to window.

Do Not Abuse: Do not directly power wash decals or scrape with ice scraper.   Windshield wipers will not hurt these decals.

 

STEP 1.  Using regular glass cleaner, clean the surface where the decal is to be applied.  If necessary, use stronger cleaners first, then go over the area with glass cleaner last.

STEP 2.  Temporarily place the decal in the desired area with a small piece of masking tape holding each end of the decal to the vehicle.  With a tape measure, align the decal with the straightest body line on the vehicle

STEP 3. Apply a long piece of tape along the top of the decal, with approx. half of the tape located on the edge of the decal and the other half on the surface of the vehicle.

STEP 4.  With the large hinged flap that is formed, raise the flap and begin to remove the backing paper, starting evenly along the top


STEP 5. 
With the backing paper half peeled downward, begin to smooth the decal to the surface of the vehicle with a squeegee or edge of credit card.


STEP 6.  Continue smoothing out the decals with long horizontal strokes, starting on top and working towards the bottom.  Continue to slowly remove the backing paper as you go.

STEP 7.  Once decal is firmly applied to surface of vehicle, peel back the transfer tape (white paper covering).

STEP 8.  Finish removing transfer tape, and with a pin, create a small hole in any remaining air bubbles.  Then with your finger or a squeegee, work out any air bubbles

 



 

"In Loving Memory" ↓     Or personalized keepsakes

Jewelry,  Mouse Pads,  Name Tags,  Checkbooks,  Key Chain Tabs,  Auto Tags,  Plastic Plaques.  

All can be personalized with your loved ones picture and dates.   Also can be used as personalized keepsakes with just picture and name.

        

 

Home Crystal pendant Jewelery Key chains Plaque (plastic) Checkbook Name tag Mouse pad Auto tag

This site is in honor of our daughter who was killed by a drunk driver on 4/4/92 please visit her memorial site at: http://angeliagisel.dovesdecals.com

We have hundreds of different graphics available that can be made into an "In Loving Memory" decal. Too many to list in this site.  If you do not see a decal graphic (graphic is the center picture inside the In Loving Memory decal)  that you like just e-mail us at: graphicinfo@dovesdecals.com  and tell us what you want.

Reproduction of this site in whole or part in any form or medium
without express written permission of Dove's Decals & Graphics is strictly prohibited.

If you are in Chattanooga Tennessee be sure to stop by: http://www.inked-4-life.com